http://dspace.nbuv.gov.ua:80/handle/123456789/74116 2026-04-13T07:15:50Z http://dspace.nbuv.gov.ua:80/handle/123456789/82488 Исследование механизма дипольных переходов в (γ,р)– и (γ,n)– реакциях на ядре ⁴He Гурьев, В.Н. 1999-01-01T00:00:00Z http://dspace.nbuv.gov.ua:80/handle/123456789/81539 Injector of the linac LU-20 Beloglazov, V.I.; Dovbush, L.S.; Myakushko, L.K.; Otlev, M.V.; Reprintsev, L.V.; Romasko, V.P.; Tur, Yu.D.; Vishnyakov, V.A.; Zakutin, V.V. The investigation have shown that the HV diode guns in combination with the forming system (collimator, deflector, buncher) are the most suitable for the use in injector accelerating structures with a high-power beam. The injector has been assembled with the linac and has been tested. In 1999 the injector had 1400 hours of operating time without accidents. The main parameters of the gun were 110 keV and 1.1 A. 1999-01-01T00:00:00Z http://dspace.nbuv.gov.ua:80/handle/123456789/81538 Radiation protection of the electron linear accelerator in production of ⁹⁹Mo Pugachev, G.D.; Popenko, V.A. 1999-01-01T00:00:00Z http://dspace.nbuv.gov.ua:80/handle/123456789/81537 Schemes of high-voltage pulse shapers on the basis of stepped transmition lines for high-current accelerators Gordeev, V.S. The systems of high-voltage pulses formation in the majority of high-current accelerators with pulse duration from several to hundreds ns are designed on the basis of single or double pulse forming lines. The disadvantage of these systems consists for a number of applications in the relatively low output voltage equal in the matched mode for a double forming line to the charging voltage while for a single line – only to a half of this value. 1999-01-01T00:00:00Z